Grooved Pins- Half- Length Grooved With Gorge; - Other pins (HS 731930)
Communiqué on TS 2337-18 Pins-Chapter 18: Grooved Pins- Half- Length Grooved With Gorge (2 page(s), in English)
This standard covers requirements for the dimensions and technical order specifications of the pins with gorge which have three equally spaced groovers empressed half length longitudinally on the exterior surface with nominal diameter 1,5 mm ≤ d1 ≤25 mm. These pins, which are pushed fit into the insertion hole at the tolerance of H11, are designed to hold the retaining rings, the washers, the springs and the like.
Pins within the scope of this standard are divided into grooved pins (Type A) to hold the retaining rings, grooved pins (Type B) for holding the washers and rounded grooved pins (Type C). Tolerance class H11 is recommended for holes in which the pin enters (pins in accordance with TS EN ISO 8750).