2019/0492/CZ
EC/EFTA
CZ Czech Republic
  • I10 - Metrology
2020-01-08
2019-10-17

multi-orifice diaphragm gas flow sensors

Draft General Measure

number:0111-OOP-C094-18,

laying down metrological and technical requirements for specified measuring instruments, including testing methods for type approval and verification of specified measuring instruments:

'multi-orifice diaphragm gas flow sensors'

Multi-orifice diaphragm gas flow sensors may be placed on the market and put into use in the Czech Republic as specified measuring instruments pursuant to Act No 505/1990 on metrology, as amended.Pursuant to this Act, specified measuring instruments are instruments that are included in the list of the types of specified measuring instruments (Implementing Decree No 345/2002) and, at the same time, intended (by the manufacturer/importer) for measurements of relevance to the protection of public interests in areas of consumer protection, contractual relations, imposition of sanctions, fees, tariffs and taxes, health protection, environmental protection, occupational safety, or the protection of other public interests protected by separate legislation.This means that their purpose is similar to that used for defining the legally controlled products – measuring instruments and non-automatic weighing instruments – under Directives 2014/31/EU and 2014/32/EU.The requirements of this legislation do not apply to measuring instruments not placed on the market in the Czech Republic for the above purposes, defined by Act No 505/1990 on metrology.

The purpose of this notified legislation is to lay down metrological and technical requirements for these specified measuring instruments.This legislation also stipulates tests for type approval and verification of specified measuring instruments of this type.

Keywords:

measuring instrument, multi-orifice diaphragm gas flow sensors, gas flow measurement