GROOVED PINS- HALF- LENGTH GROOVED WITH GORGE
Communiqué on TS 2337-18 Pins-Chapter 18: Grooved Pins- Half- Length Grooved With Gorge
- This standard covers requirements for the dimensions and technical
order specifications of the pins with gorge which have three equally
spaced groovers empressed half length longitudinally on the exterior
surface with nominal diameter 1,5 mm ≤ d1 ≤25 mm. These pins, which are
pushed fit into the insertion hole at the tolerance of H11, are designed
to hold the retaining rings, the washers, the springs and the like.
- Pins within the scope of this standard are divided into grooved
pins (Type A) to hold the retaining rings, grooved pins (Type B) for
holding the washers and rounded grooved pins (Type C).
- NOTE: Tolerance class H11 is recommended for holes in which the pin enters (pins in accordance with TS EN ISO 8750).