SI 32 part 1.1: Plugs and socket outlets for household and similar purposes: Plugs and socket-outlets for single phase up to 16A - General requirements (165 page(s), in English; 27 page(s), in Hebrew)
Revision of the Mandatory Standard SI 32 part 1.1. This draft standard revision adopts the International Standard IEC 60884-1 - Edition 3.2: 2013-02,
with the following changes that appear in the Hebrew section:
• Changes the standard's scope as follows:
o Narrows the standard's scope to apply to plugs and fixed or portable socket-outlets with a rated voltage greater than 50 V but not exceeding 250V and a rated current not exceeding 16A. The products removed from this standards scope will be included in the future standard SI 32 part 1.2;
o Removes from the standard's scope the second phrase "The rated current is limited to 16 A maximum for fixed socket-outlets provided with screwless terminals";
o This standard applies also to: plugs that are part of a cord sets, plugs and portable plugs that are part of a cord extension sets, including plugs and portable socket outlets with one or few outlets, and to plugs and socket-outlets which are a component of an appliance;
o The scope was extended to apply also to permanent plugs that include one device such as: switch, fuse or USB supply;
• Adds new definitions to paragraph 3;
• Removes the ratings requirements for 32A detailed in Table 1 of paragraph 6;
• Prohibits the use of equipment type 0 and type 01 as specified in Israel mandatory standard SI 900 part1;
• Adds new marking requirements to paragraph 8 for wires with nominal cross section of 2.5mm2 and according to this amends paragraphs 12.2 and 23.2;
• Replaces the first section of paragraph 9.1 and provides a new Table 201, that provides new dimensions for the accessories according to figures 203-212;
• Adds new requirements to paragraph 10 dealing with protection against electric shock.